Elite Pole Accessory – Aluminium
- Additional information
- Garden Zone Installation
|Dimensions||5 × 45 × 5 cm|
|Fitting Height|| |
|Integrated LED|| |
|Build Materials|| |
|Country of Origin|| |
|Made in England|| |
PLUG & GO: HOW IT WORKS
Step 1: Choose the areas you want to have lit, then we suggest that you sketch a rough plan view of each area involved.
Step 2: Choose the fi ttings which will suit the requirements and list them out with the quantity of each where relevant. Be careful to bear in mind the voltage of the fi ttings chosen. All 220-240V fi ttings will need mains supply to wherever they are to be installed whereas all plug & go models just need to be connected into the low voltage cable (as shown below).
Step 3: Measure the distance involved for the plug & go models chosen and determine, from the cable set options available which cable set or sets will be needed. Remember, up to 80 metres of cable can be used from 1 LED driver but the wattage loading must not exceed the recommended minimum, maximum (see accessories page 209).
Step 4: Plan where the mains supply will originate from. With the plug & go system you have a choice of placing the LED driver/drivers in an IP rated wall box on an exterior wall. However, depending on how large an area is involved, sometimes more than one mains feed may be needed in diﬀ erent locations. Consultation with an electrician is advisable on this matter.
Plug & go fittings use a unique single pin, 2 pole plug and as such are not compatible with any other product or system. Currently they are not dimmable but they will work when wired via a timer.